Rust-oleum Stops Rust Protective Enamel Spray Paint - Flat Black

Rust-oleum stops rust protective enamel. It's never been easier to refinish, refresh, and relax. It is designed to provide a durable protective coating with excellent rust prevention, and excellent resistance to abrasion, fading, chipping, and dulling. These sprays apply easily, provide excellent coverage, and dry fast to a tough attractive finish.

Rust-oleum stops rust enamel sprays are ideal for ferrous, non-ferrous metal and wood surfaces. It features a comfort tip with a wider finger pad to reduce fatigue caused by continuous spraying and an any-angle tip which allows you to spray at any angle.

Features

• Ultra-durable, corrosion-resistant spray paint
• Superior coverage over a variety of surfaces such as metal, wood, ceramic and more
• Indoor/outdoor use
• Beautiful finish with long-lasting color
• Any-angle spray system allows you to spray at any angle for those hard to reach areas
• Comfort spray tip helps eliminate finger fatigue for those larger projects

For Best Result

For heavily rusted surfaces, apply rust-oleum stops rust rusty metal primer. For uncoated metal, apply stops rust clean metal primer. For difficult to adhere surfaces, apply stops rust universal bonding primer.

Application

Use outdoors or in a well-ventilated area such as an open garage. Use when the temperature is between 50°-90°f (10°-32°c) and humidity is below 70% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°f (93°c) or galvanized metal. Avoid spraying in very windy, dusty conditions. The cover surrounding area to protect from spray mist.

Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle do not strike can. Contact rust-oleum. Shake often during use. Hold can upright 10-16" from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart to avoid runs and sags. Do not use near an open flame.

Dry and Recoat Times

Based on 70° f (21°c) 50% relative humidity. Allow more time at cooler temperatures. Dries tack-free in 2-4 hr, to handle in 5-9 hr and fully dry in 24 hr. Primers may be top coated immediately. Apply a second coat or clear coat within 1 hr or after 48 hr.

Cleanup

Wipe off the tip before storing it. Clean up wet paint with xylene or mineral spirits. Throw away empty can in trash pickup. Do not burn or place in the home trash compactor.

Clogging

If valve clogs, twist and pull off spray tip and rinse it in a solvent such as mineral spirits. Do not stick a pin or other objects into the stem.

Surface Preparation

Remove all dirt, grease, oil, salt, and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning methods. Rinse with freshwater and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.

Warning

If you scrape, sand or remove old paint from any surface, you may release lead paint dust. Lead is toxic. Exposure to lead dust can cause serious illness, such as brain damage; especially in children. Pregnant women should also avoid exposure. Wear a niosh approved respirator to control lead exposure. Clean up carefully with a hepa vacuum and a wet mop.

Specifications

• Color: Flat Black
• Resin Type: Oil Modified Alkyd
• Solvents: Acetone, N-Butyl Acetate, Aromatic Hydrocarbons
• Dry Heat Resistance: 200°F (93°C)
• Flash Point: 156°F (69°C)
• Size: 12 oz

Safety Data Sheet.pdf