Minwax Clear Pre-stain Wood Conditioner - 1/2 Pt

Minwax Pre-Stain Wood Conditioner Prepares Bare Wood For Staining. It Penetrates The Grain Of The Wood To Promote Uniform Acceptance Of Oil-based Stains.

Features

• Treating The Surface With Pre-Stain Wood Conditioner Helps Prevent Streaks And Blotches By Evening Out The Absorption Of Oil-based Stains.
• It Can Be Applied Over Any Wood But Is Especially Necessary When Working With Soft Or Porous Woods Like Pine, Alder, Birch, And Maple.

Directions

• Before Staining, Apply Minwax Pre-Stain Wood Conditioner On Clean, Raw Wood, Using A Brush Or Cloth.
• Allow To Penetrate For 5 To 15 Minutes, Then Remove Any Excess With Clean, Dry Cloth.
• Apply Stain Within Two Hours Of Application Of Pre-Stain Wood Conditioner. For Best Results, Stain With Minwax Wood Finish, Minwax Gel Stain, Or Minwax PolyShades.

Specification

• Pint: 1/2 Pt
• Color: Clear
• Application Tool: Cloth Or Brush
• Recoat: After 15 Minutes, But No More Than 2 Hr
• Dry Time: 15 Minutes
• Cleanup: Mineral Spirits Or Paint Thinner, Following Manufacturer’s Safety Instructions
• Coverage: 125 Sq. Ft./qt
• Coats: Normally 1, But Additional Coats May Be Applied On Highly Absorbent Woods
• Recommended Uses: On Soft Or Hardwoods Before Using Oil-based Wood Stains
• Warning: Removal Of Old Paint By Sanding, Scraping Or Other Means May Generate Dust Or Fumes That Contain Lead. Exposure To Lead Dust Or Fumes May Cause Brain Damage Or Other Adverse Health Effects, Especially In Children Or Pregnant Women. Controlling Exposure To Lead Or Other Hazardous Substances Require The Use Of Proper Protective Equipment Such As A Properly Fitted Respirator (NIOSH Approved) And Proper Containment And Cleanup.

Safety Data Sheet.pdf