Zoom the image with the mouse
Minwax Pre-stain Wood Conditioner - 1 qt
SKU:
545988
UPC:
027426615007
$22.99
Minwax pre-stain wood conditioner prepares bare wood for staining. It penetrates the grain of the wood to promote uniform acceptance of oil-based stains.
Features
- Treating the surface with pre-stain wood conditioner helps prevent streaks and blotches by evening out the absorption of oil-based stains
- It can be applied over any wood but is especially necessary when working with soft or porous woods like pine, alder, birch, and maple
- Normally 1 coat but additional coats may be applied on highly absorbent woods
Directions
Surface Preparation:
- Before staining, apply Minwax pre-stain wood conditioner on clean, raw wood, using a brush or cloth
- Allow to penetrate for 5 to 15 minutes, then remove any excess with clean, dry cloth
- Apply stain within two hours of application of pre-stain wood conditioner. For best results, stain with Minwax wood finish, Minwax gel stain, or Minwax polyshades
Specifications
- Size: 1 qt
- Application Tool: Cloth Or Brush
- Recoat: 15 Min - 2 hr
- Dry Time: 15 Min
- Cleanup: Mineral Spirits Or Paint Thinner, following Manufacturer's Safety Instructions
- Coverage: 125 sq ft
- Number Of Coat: 1 Coat
- Recommended Uses: On Soft Or Hardwoods Before Using Oil-based Wood Stains
- Certified: Conforms To ASTM D-4236.
- Coverage: 125 sq ft per qt
- Cautions: Contains Aliphatic Hydrocarbons, Contents Are Combustible. Keep Away From Heat And Open Flame
WARNING: This product can expose you to chemicals including Toluene, Mineral spirits (Stoddard solvent), which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Minwax pre-stain wood conditioner prepares bare wood for staining. It penetrates the grain of the wood to promote uniform acceptance of oil-based stains.
Features
- Treating the surface with pre-stain wood conditioner helps prevent streaks and blotches by evening out the absorption of oil-based stains
- It can be applied over any wood but is especially necessary when working with soft or porous woods like pine, alder, birch, and maple
- Normally 1 coat but additional coats may be applied on highly absorbent woods
Directions
Surface Preparation:
- Before staining, apply Minwax pre-stain wood conditioner on clean, raw wood, using a brush or cloth
- Allow to penetrate for 5 to 15 minutes, then remove any excess with clean, dry cloth
- Apply stain within two hours of application of pre-stain wood conditioner. For best results, stain with Minwax wood finish, Minwax gel stain, or Minwax polyshades
Specifications
- Size: 1 qt
- Application Tool: Cloth Or Brush
- Recoat: 15 Min - 2 hr
- Dry Time: 15 Min
- Cleanup: Mineral Spirits Or Paint Thinner, following Manufacturer's Safety Instructions
- Coverage: 125 sq ft
- Number Of Coat: 1 Coat
- Recommended Uses: On Soft Or Hardwoods Before Using Oil-based Wood Stains
- Certified: Conforms To ASTM D-4236.
- Coverage: 125 sq ft per qt
- Cautions: Contains Aliphatic Hydrocarbons, Contents Are Combustible. Keep Away From Heat And Open Flame
WARNING: This product can expose you to chemicals including Toluene, Mineral spirits (Stoddard solvent), which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
