Rust-oleum Stops Rust Enamel Spray Paint- 12 oz

Transform heavily-rusted metal into a paintable surface with rust-oleum stops rust rusty metal primer. This primer bonds tightly to rust and forms a surface topcoats can adhere to while driving out the corrosive air and moisture other primers leave behind.

It provides a sound the base for the application of stops rust enamels on heavily rusted metal. The use of primers promotes topcoat adhesion and helps prevent chipping, cracking, and peeling and eliminates the need for multiple coats of the enamel finish. It features a comfort tip with a wider finger pad to reduce fatigue caused by continuous spraying and the any-angle tip which allows you to spray at any angle.

Features

• Provides more than twice the rust protection of using enamels alone
• Indoor/outdoor use
• Durable, corrosion-resistant

For Best Results

Apply two or more light coats a few minutes apart.

Applications

Shake can vigorously for one minute after mixing ball begins to rattle. If mixing ball fails to rattle do not strike can. Contact rust-oleum. Shake often during use. Hold can upright 10-16" from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart to avoid runs and sags. Do not use near an open flame.

Dry and Recoat Times

Based on 70°F(21°C) 50% relative humidity. Allow more time at cooler temperatures. Dries tack-free in 2-4 hr, to handle in 5-9 hr and fully dry in 24 hr. Primers may be top coated immediately. Apply a second coat or clear coat within 1 hr or after 48 hr.

Cleanup

Wipe off the tip before storing it. Clean up wet paint with xylene or mineral spirits. Throw away empty can in trash pickup. Do not burn or place in the home trash compactor.

Clogging

If valve clogs, twist and pull off spray tip and rinse it in a solvent such as mineral spirits. Do not stick a pin or other objects into the stem.

Painting Conditions

Use outdoors or in a well-ventilated area such as an open garage. Use when the temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. The cover surrounding area to protect from spray mist.

Surface Preparation

Remove all dirt, grease, oil, salt, and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning methods. Rinse with freshwater and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.

Warning

If you scrape, sand or remove old paint from any surface, you may release lead paint dust. Lead is toxic. Exposure to lead dust can cause serious illness, such as brain damage; especially in children. Pregnant women should also avoid exposure. Wear a niosh approved respirator to control lead exposure. Clean up carefully with a hepa vacuum and a wet mop.

Specifications

• Size: 12 oz
• Resin Type: Modified Alkyd
• Solvents: Acetone, Toluene, Xylene
• Dry Heat Resistance: 200°F (93°C)
• Flash Point: -156°F (-104°C)

Safety Data Sheet.pdf