Zircon Studsensor Pro45 Stud Finder - 6-3/4"

The deep-scanning StudSensor Pro45 stud finder features a patented ergonomic grip to make stud finding quick and simple. It features a bright user-friendly interface to locate the edges of wood and metal studs and joists while being warned of live, unshielded AC electrical wiring. Securely anchor pictures, mirrors, shelves, and more.

Features

• StudScan Mode locates the edges of wood and metal studs up to 3/4" (19mm) deep
• DeepScan Mode doubles the scanning depth to 1-1/2" (38mm) deep
• Ready light indicates when calibration is complete and tool is ready for use
• Edge arrow lights up sequentially as the tool approaches a stud and fully illuminates when the stud edge is located
• Zircon’s patented “over-the-stud” feature alerts if scan begins over a stud
• WireWarning Detection indicates the presence of live, unshielded AC electrical wiring up to 2" (50mm) deep
• SpotLite Pointer shines an arrow-shaped image on the scanned surface to clearly indicate the edge of the stud
• A “V” marker groove enables accurate marking of stud edge location
• Ergonomic grip for a secure hold in either hand at any angle

Position Accuracy

• Wood Studs: Typically Within 1/8" (3mm) Using The Dual Scan And Mark Procedure
• Metal Studs: Typically within 1/2" (13mm) using the dual scan and mark procedure

Depth

• StudScan Mode: Up To 3/4" (19mm)
• DeepScan Mode: Up To 1-1/2" (3mm)

Specifications

• Battery Type: 9V Alkaline, required
• Operating Temperature: 20° To 105°F (-7° To 41°C)
• Storage Temperature: -20° To 150°F (-29° To 66°C)
• Humidity: 5-90% RH (non-condensing)
• Water Resistance: Splash And Water-resistant, Not Waterproof
• WireWarning Depth: In Typical Wall With Romex Wiring, The Wire Canbe Detected Up To 2" (50mm) Deep
• WireWarning Position Accuracy: Typically 90-250V At 50-60Hz Within 6" (150mm) of a hot unshielded wire
• Weight: 4.4 oz Without Battery
• Height: 6-3/4"
• Width: 2-7/8"
• Depth: 1-5/8"

Technical Sheet.pdf

Manual Instructions.pdf